STEP 1

Use a hair dryer to blow heat
at the edge of the ACMAXX protector for 25~30 seconds.
Keep distance of the hair dryer from the protector about 5 inch/10cm.

Note: Please DO NOT OVER
HEAT protector or your camera.
It might cause damage.

STEP 2

While blowing heat to the protector, try to remove the protector with your
finger nail. It should be easily lift off from your camera.

STEP 3

Use your finger to remove the protector. DO NOT use any
sharp tool to remove it because
it might cause damage.

STEP 4

Carefully remove the protector from your camera. Now you can clean or replace a new ACMAXX protector.